Cool Treat

Item Code: RXSOL-40-4012-025

• Balanced composition
• Easy to use
• Environmentally friendly

• Liquid product, easy to use. environmentally friendly, fully organic product, low toxicity
• Effective against cavitation and erosion
• Superior heat transfer properties
• Compatible with hoses, gaskets and seals
• Compatible with glycol for frost protection
• Stable product - non depleting
• The product can be used for corrosion inhibition in many types of closed re-circulation system such as
• Diesel engine cooling water systems - Compressor cooling water systems
• Centralized cooling systems Hot water healing systems Auxiliary machinery cooling systems

• Rx Sol Cool treat is a highly effective corrosion inhibitor for all common metals in cooling water systems
• Where most traditional inhibitors react with the metal surface and form oxides that prevent further corrosion
• Cool treat applies a thin and durable layer of Protective molecules to the metal surfaces
• This technology prevents the continuous build-up of insulating layers on heat transfer surfaces
• For new builds, Rxsol recommends cleaning of the water system before commencing service
• The system will always contain small amounts of oil and iron oxides, and this can be easily removed in
• 1 time with Pxsol Commissioning Cleaner. If the system Is corroded or is more heavily contaminated use Rxsol Degrease hd
• Pxsol Safe Acid for removal of metal oxides or scale is recommended
• For systems previously treated with other products, Wilhelm-sen
• Ships Service recommend to drain and flush the system before refilling with distilled water and Cool treat
• The system should be clean and free from scale and corrosion products when starting the treatment
• The use of antifreeze is sometimes required if the vessel is to be laid up in cold areas
• Cool treat can be used in conjunction with glycol for frost protection
• If used in conjunction with glycol, It is recommended to increase the product concentration to 8%

• Cool treat should be dosed to a suitable point in the system
• If the expansion tank is used, adequate circulation must be assured

• Cool treat should always be present in a concentration of 5% or higher in the system.
• It is good practice to start with initial dose for an untreated system of
• Go liters of Cool treat ton, 5% will provide sufficient protection of the system for a period of two to five years under normal conditions provided
• To prevent residual falling below minimum level due to loss of cooling water,
• Wilhelm-sen Ships Service recommend to maintain a level of 6% Cool treat in the cooling system
• The engine manufacturer's recommendations for water quality should always be complied with
• Cool treat provides good protection even with contamination of the system by i.e
• Inorganic salts.Maintain Chloride levels and other contaminants at a minimum level
• Most engine manufacturers recommend a maximum of 50 ppm Chlorides

• Density: 1.06
• Packing type: 25 ltr
• Color: Colorless
• Appearance: liquid