gear pumping principle was invented by Jens Nielsen, one of the founders of
Viking Pump. It uses two rotating gears which un-mesh at the suction side of
the pump to create a vacuum which pulls fluid into the pump. The spaces between
the gear teeth transport the fluid on either side of a crescent to the
discharge side, and then the gears re-mesh to discharge the fluid. We are an
authorized stocking distributor for Arizona & Nevada.
Easy to Maintain - Only two moving parts.
Clearance - For low or high viscosities, high temperatures, or to compensate
for wear over time.
Options - Including packed gland, lip seal, component seal, cartridge seal and
sealless mag drive options.
- Viking's broadest selection of port locations, configurations, and types.
Pulsation - For accurate flow measurement.
One Shaft Seal -
More reliable and lower cost than two used on timed lobe and screw pumps.
Options - For motor speed operating or with gear motors.